Later, the bracket held a heavy pump during a pressure test. No cracks, no leaks.
Marco shrugged. He’d done flat welds before. He struck an arc. horizontal position in welding
“Yeah.”
Marco was a second-year welding apprentice working on a water treatment plant upgrade. His task: weld a support bracket onto a 12-inch horizontal steel pipe that carried non-potable water. The pipe was stationary, about chest-high, and the weld was a simple fillet—a perfect opportunity to practice. Later, the bracket held a heavy pump during a pressure test
“Flat, of course,” Marco said, pointing to the top of the pipe. “The bracket goes here.” He’d done flat welds before
Marco ground out his mess and tried again. This time, he tilted the electrode 5–10 degrees upward, kept a tight arc, and moved steadily. He watched the puddle solidify like a tiny shelf, each ripple locking in place before the next. The weld was flat on top, slightly convex on the bottom face, and fully fused.
Within three inches, his molten puddle sagged. The top bead looked fine, but the toe on the lower side was jagged—metal had dripped downward before solidifying. He tried speeding up, but that just created cold lap. Frustrated, he chipped off the slag and saw the truth: a weak, uneven weld with undercut along the bottom edge.