!new! | Lokfix P80

Slide the parts together with a twisting motion to spread the adhesive evenly. Do not "pump" the parts in and out—this introduces air bubbles.

Apply 360 degrees around the inner surface (for housings) or outer surface (for shafts). For vertical shafts, apply to the leading edge of the pin so it spreads during insertion. lokfix p80

Use a solvent cleaner (acetone or Loctite 7063). Remove all oil, grease, and old threadlocker. The surface must be "water-break free" (where water forms a sheet, not droplets). Slide the parts together with a twisting motion

When a shaft wears down or a bearing housing becomes ovalized, the traditional solution is often expensive: welding, machining, or replacing the entire assembly. But there is a third path—one that lives inside a small bottle. Enter . lokfix p80